MANUFACTURING CAPABILITIES · MATERIAL GUIDE MANUFACTURING CAPABILITIES Lathe Cut Gaskets--------------------------------- * Small quantities with low minimum charges * Larger quantities released monthly * Parts as small as 3/4" inside diameter. * Parts as large as 42" outside diameter. * CNC cutting for tight tolerances.Rubber Roll Covering--------------------------------- * Regrinding / Redressing of existing surfaces. * Removal of old covering & core repair. * Min. 3/4" to max. 36" outside diameter. *Provide New Core Fabrication * Special Grooving & Contoured FinishesStripper Rings--------------------------------- * Maximum 30" outside diameter. * Single, dual and even triple durometer. * Nitrile, neoprene or cast urethaneCNC Billets--------------------------------- * Raw Material for Custom Seal Manufacturers * Custom Sized Billets-Reduce Waste * Made in the U.S.A. * Freight Savings * Short Lead Times & Same Day QuotesLathe Cut Gasket Blanks--------------------------------- * Used to save material when punching or flash cutting. * Eliminate the need to cut a full sheet * Save Corners and EdgesMain Office and Manufacturing Plant 306 Halstead Blvd Zelienople, PA 16063 ​ Email: info@eaglerubber.com Tel: 724-452-3200 Fax: 724-452-3205 CONTACT Manufacturing CapabilitiesMaterial GuideCONTACTDownload Material GuideEagle Rubber Products is a custom manufacturer of rubber elastomer parts. Our parts are "lathe cut" but more importantly "lathe built" which allows for larger sizes, reduced waste and usually no tooling or set up charges. We specialize in large parts with IDs of up to 42 inches. We provide parts made from a wide range of rubber elastomers including customer supplied raw materials or formulations. Our capabilities include the manufacture of Lathe Cut Gaskets, Stripper Rings for the slitting industry, CNC Machine Billets, as well as Lathe Cut Gasket Blanks and Rubber Roll Covering. We are serving a broad spectrum of industries throughout the world.